
Amplifier
Refine Search
- POWER SUPPLY:9-15Vcc
- STANDBY CURRENT:<1.2A
- INPUT SENSIVITY:0.4-8V
- INPUT IMPEDANCE:48KΩ
- OUTPUT POWER 4Ω @ 12V/14.4V:115/135Wx2
- OUTPUT POWER MONO 4Ω @ 14.4V:415Wx1
- FREQUENCY RESPONSE:±dB 7Hz-70KHz
- SIGNAL/NOISE RATIO:<100dB
RM5,672.00
- Maximun Speaker Level Input :60watts@4 ohms
- Maximun Output Level : 9.5Vrms
- Output Gain : +/-12dB
- Frequency Response : 10Hz-22kHz
- Total Harmonic Distortion : 0.01%
- Input Impedance : 180 ohms
- Power Supply : High Headroom PWM Switching
- Power Draw : 200mA
- Recommended Fuse Rating : 1 Amp
- Remote Trigger Output Current : 1 Amp Max
RM1,188.00
- Minimum speaker load : 2 Ohm at Stereo , 4 Ohm at Mono
- Input sensitivity : 0.2 - 5.0 Volt
- Frequency response : ( +/- 1dB ) : 10Hz - 20kHz
- Bass Boost : 0dB , 6dB , and 12dB
- Remote on/off : No '' pop '' noise when turn on/off
- Fuse : 2 x 25 amperes
- Low pass filter ( LPF ) : 50 - 250 Hz
- High pass filter ( HPF ) : 50 - 200 Hz
- Total harmonic distortion ( THD ) at 4 Ohm load : < 1%
- Signal to Noise Ratio ( SNR ) : > 90dB ( without filter )
- Efficiency at 4 Ohm load : > 68%
- Working voltage ( DC ) : 9 - 16 volt
- Low voltage protection : Available , protect < 9 volt
- Short circuit test at max power : Tested
- Overheat protect : Protect at 80ºC / 176ºF
RM728.00
- Minimum speaker load : 2 Ohm
- Input sensitivity : 0.2 - 5.0 Volt
- Frequency response : 10 - 220 Hz
- Remote on/off : No ''pop'' noise when turn on/off
- Fuse : Not available
- Low pass filter ( LPF ) : 40 - 220 Hz
- High pass filter ( HPF ) : OFF - 50 Hz
- Total harmonic distortion (THD) at 4 Ohm load : < 0.30%
- Signal to Noise Ratio (SNR) : > 80dB
- Bass Boost : Switchable : 0dB - 12dB
- Efficiency at 4 Ohm load : > 80%
- Remote control : Optional
- Low voltage protection : YES , protect < 8 Volt
- Short circuit test at max power : Tested
- Overheat protect : Protect at pass 80ºC / 176ºF
RM1,288.00
- Minimum speaker load : 2 Ohm
- Input sensitivity : 0.2 - 5.0 Volt
- Frequency response : 10 - 220 Hz
- Remote on/off : No ''pop'' noise when turn on/off
- Fuse : Not Available
- Low pass filter ( LPF ) : 40 - 220 Hz
- High pass filter ( HPF ) : OFF - 50 Hz
- Total harmonic distortion ( THD ) at 4 Ohm load : < 0.30 %
- Signal to Noise Ratio ( SNR ) : > 80dB
- Bass Boost : Switchable : 0dB , 6dB , and 12dB
- Efficiency at 4 Ohm load : > 80%
- Remote control : Optional
- Low voltage protection : YES , protect < 8 volt
- Short circuit test at max power : Tested
- Overheat protect : Protect at pass 80ºC / 176ºF
RM2,578.00
- Power rating ( RMS ) : 4 x 100 Watts at stereo 4 Ohm load , 4 x 100 Watts at stereo 2 Ohm load , 2 x 300 Watts at bridged 4 Ohm load
- Minimum speaker load : 2 Ohm at stereo mode , 4 Ohm at bridge mode
- Frequency response : 20Hz - 20kHz
- Remote on/off : No '' pop '' noise when turn on/off
- Fuse : 40A
- Damping Factor : 32 at kHz , 104 at 50 Hz
- Siew rate : 5 volt per microsecond
- Signal to Noise Ratio ( SNR ) : 85dB
- Total harmonic distortion : 0.03% at 1 kHz , 0.05% at 6 kHz
- Channel separation : 70dB
- Rail voltage : +36 and -36 volts
- Input impedance : 22 kOhm
- Efficiency : 73%
RM3,196.00
- Power rating ( RMS ) : 6 x 100 Watts at stereo 4 Ohm load , 6 x 100 Watts at stereo 2 Ohm load , 3 x 300 Watts at bridged 4 Ohm load
- Minimum speaker load : 2 Ohm at stereo mode , 4 Ohm at mono mode
- Input sensitivity : 0.2 - 4.0 Volt
- Frequency Response : 20 Hz - 20 kHz
- Remote on/off : No '' pop '' noise when turn on/off
- Fuse : 2 x 30 Ampere
- Damping factor : 32 at 1 kHz , 104 at 50 Hz
- Siew rate : 5 volt per microsecond
- Signal to Noise Ratio ( SNR ) : 85dB
- Total Hamonic Distortion : 0.03% at 1 kHz , 0.05% at 6kHz
- Channel Separation : 70dB
- Rail voltage : +36 and -36 Volts
- Input impedance : 22 kOhm
- Efficiency : 73%
RM2,778.00
- Speaker load : 2 Ohm , 4 Ohm
- Output power ( RMS ) : 2 x 300 Watt , 2 x 150 Watt stereo and 1 x 350 Watt bridge mono
- Minimum speaker load : 2 Ohm at stereo , 4 Ohm at mono
- Input sensitivity : 0.2 - 5.0 Volt
- Frequency response : 10 Hz - 25 kHz
- Remote on/off : No '' pop '' noise when turn on/off
- Fuse : 40 Ampere
- Low pass filter ( LPF ) : 50 - 750 Hz
- High pass filter ( HPF ) : 50 - 750 Hz
- Total harmonic distortion ( THD ) at 4 Ohm load : < 0.02%
- Signal to Noise Ratio ( SNR ) : > 90dB
- Efficiency at 4 Ohm load : > 60%
- Low voltage protection : Available , protect < 8 Volt
- Short circuit test at max power : Tested
- Overheat protect : Protect at 80ºC / 176ºF
RM2,798.00
- Speaker load : 4 Ohm , 2 Ohm
- Output power ( RMS ) : 6 x 75 Watts stereo , 3 x 250 Watt bridged , 6 x 115 Watt stereo
- Minimum speaker load : 2 Ohm at stereo and 4 Ohm at Bridged
- Input sensitivity : 0.2 - 5.0 Volt
- Frequency response : 10 Hz - 25 kHz
- Remote on/off : No '' pop '' noise when turn on/off
- Fuse : Not Available
- Low pass filter ( LPF ) Ch.5/6 : 10Hz ( OFF ) - 750 Hz
- High pass filter ( HPF ) Ch.1/2/3/4 : 10Hz ( OFF ) - 200 Hz , Ch.5/6 : 10Hz ( OFF ) - 750 Hz
- Total Harmonic Distortion ( THD ) at 4 Ohm load : < 0.05%
- Signal to Noise Ratio ( SNR ) : > 90dB
- Low voltage protection : YES , protect < 8 Volt
- Short circuit test at max power : Tested
- Overheat protect : Protect at pass 80ºC / 176ºF
RM3,778.00
- Freq response : 10Hz ~ 22KHz
- Input impedance : Low level input : 20kOhm , High level input : 240Ohms
- Low level output : 100Ohms
- Power output ( 4Ohms ) : RMS 65W x 4 , Peak power 130W x 4
- Signal input / output range : RCA input : 3.3Vpp ; High level : 30Vpp ; RCA output : 13.0Vpp
- Supply Voltage : DC 11V ~ 15V
- Turn-on REM output : +12V starting voltage output ( 0.1A )
RM1,590.00
- Gain control
- Filter control
- Low level input
- Subsonic control
- MOSFET power supply
- 1 ~ 4 Channel power amplifier
- Bass freq control
- Bass boost control
- Thermal protection
- Short circuit protection
- Remote Turn-on / Turn-off circuit
- LED power and protection indicator
RM585.00
- 14.6 volts automotive voltage stabilizer with volt display
- Improved audio quality
- Improved battery life
- Improved amplifier efficiency
- Voltage stabilizing function : To solve too high or too low voltage problems
- Input voltage : 10-14V DC
- Output voltage : 14.6V DC
- Peak current : 70A
RM680.00
- 4 Ohm / 2 Ohm stable Stereo
- Power & Protection indicator
- Variable highpass
- Variable lowpass
- Auto-On @ High Level Input
- Adjustable input sensitivity
- Soft delayed remote turn- on
- Bass remote (optional)
- Thermal / Short / Overload protection
RM1,380.00
- 2 Ohm stable stereo
- Adjustable BIAS control (for each pair of channels separately)
- High End WIMA® Capacitors
- Latest BURR-BROWN® operational amplifiers
- Status LED
- Wide-band adjustable high pass & low pass filters
- Band-pass feature with activated LPF & HPF
- Adjustable input sensitivity
- Soft delayed remote turn on
- Thermal / speaker short circuit / overload / over current protection
- Temperature sensor controlled cooling fan
RM5,588.00
- 4-channel amplifier
- Class AB technology
- Variable active crossover and bass boost
- Stable power supply
- anodized heatsink with Ground Zero lettering
RM1,380.00
- 4-channel amplifier
- Class AB technology
- Variable active crossover and bass boost
- Stabilized power supply
- Covered terminals
- Solid heatsink with Ground Zero lettering
RM1,950.00